Providing Internet Access to a "remote" Real server

Hi,

I’m new to F5 world. I’m trying to figure out how to give Internet access to my real server (for systeme upgrades / systeme ISO installations etc..). This real is reachable via internal routing from the BigIP, I did try to use SNAT, but this doesn’t seems to do the trick. What is the common procédure for this kind of need ?

Thanks

David

Is the BIG-IP being relied upon to route the traffic out? Is this necessary? I ask as the server clearly isn’t using the BIG-IP as it’s default gateway.

real server, do i see a Cisco ACE term there :slight_smile:

if you are talking about a node which needs to be able to access the internet through the BIG-IP you need to setup a virtual forwarding server on the big-ip which allows access from the server side of the big-ip to the client side (assuming basic setup).

Did you want your real server to be able to access the internet(outbound)? Is your BigIP and real server on the same subnet? In this case you’ll have to set up the BigIP as your default gateway for the real server to get out to the internet via the BigIP, and you’ll need a virtual forwarding server on the BigIP.

Or access from the internet to your real server(Inbound)? In this case you’ll need a Virtual forwarding server for this

I believe the above is correct if I understand your question.

Leonardo

This is for outbount and no they’re not on the same subnet cheers

If it’s outbound and you want to use the BigIP you’ll have to somehow get the BipIP in the path out to the internet. Otherwise when your real server tries to go out to the internet, using an public IP, it’ll just follow its path out to the internet, there isn’t anything to tell it to go to the BigIP first. Make sense?

well, the BigIP will have to NAT the request, and that is my point :slight_smile: how do you do this when the real server isn’t on the same LAN as the BIG-IP.

Might be easier to setup a static NAT on your router. Do you have an available publicly routable IP address/NAT pool to use for the external NAT address?

Router in not on the Internet

please answer the last question from Leonardo. in principle if you just route traffic from the real server through the big-ip and have a forwarding virtual server listening there with SNAT enabled it should work.