Mount USB memory stick

not sure where this should go, but will try here.

Is there a document our procedure to mount a usb memory stick on an LTM running 9.3.1.

Purpose would be to move files back and forth to a device that may be off line.

I am not asking about booting from USB CDROM. Looked at askf5 and could not find anything.

Thanks!

jrstewart -

The drive will need to be formatted with FAT or FAT32. Do the following:

1. Plug the drive into the USB slot

2. type:

dmesg | grep "SCSI device"

…and make note of the device identifier (which should be ‘sda’ or something along those lines)

3. type:

mkdir /mnt/usbdrive

4. then:

mount -t vfat /dev/sda /mnt/usbdrive

5. finally:

cd /mnt/usbdrive

…which should put you into the USB drive. When you need to pull the thumbdrive, do:

cd /; umount /dev/sda

makes sense, get an error, wonder what sticks work

The only reference I could find is from the release notes:

* USB Consortium as a Mass Storage Device certified

* USB version 2.0 or later

* 512 MB minimum capacity, recommended 1 GB capacity

The device capacity and capabilities are described in the following table.

Note: While smaller capacity devices are supported, we recommend using a device with at least 1 GB capacity.

If a key works for the installation, I’d expect it would be mountable after installation.

Aaron