Hi all,
I need to know is it possible to configure application security policy (waf) for virtual server if the ASM and LTM are two different separated devices? If it is possible how can I do that?
Hi all,
I need to know is it possible to configure application security policy (waf) for virtual server if the ASM and LTM are two different separated devices? If it is possible how can I do that?
Perhaps im not understanding to the question. But the only place would be the ASM device then. Why would that be a problem for you?
You can still have virtual servers and pools on the ASM device, the pool might be the virtual server on the LTM device.
What I know, ASM and LTM on same physical device usually, so when we create asm policy you can attach it the virtual server because they are exist on same device.
But when ASM on dedicated physical device and LTM on another different device how can the waf policy inspect the traffic going to VS?(I can’t attach the policy to the VS because it’s on another device)
Should I create same VS and same pools with same names on the asm and ltm or what?
You create a new virtual server on the ASM device, attached the policy to that. In the pool of that virtual server you can use the virtual server on the other LTM device as the node.
Names don’t matter, you do have to have the networking surrounding it to make sure the client can reach the virtual server on the ASM device and the ASM device reach the virtual server on the LTM device.
The question is why two seperate devices? There might be no need to do that, but this all becomes quite involved for a forum question. Is there another person at the company who can explain something? Or can you find similar setups from the ASM device point to the LTM device? Perhaps the company that sold the F5s, they might have a service to help with understand the setup.
Thanks for your response.
Hi @f10
LTM is the base module on the F5 BIG-IP. All virtual servers are created under LTM, and other profiles and policies, including ASM/AWAF policies, are applied to these virtual servers.
Since ASM requires a virtual server, you need to configure the virtual servers on the F5 device where ASM is enabled. So you would need both LTM & ASM. The backend virtual servers on the other F5 device, which has only LTM, can be configured as pools on the ASM-enabled device as mentioned by @boneyard .
However, I would also like to understand why you need two separate devices. If your plan is to run an F5 device with only an ASM/AWAF license, thenthat is not possible, as LTM is the base module and ASM, APM, etc., are add-on modules that runs alongwith LTM.
Hope this helps!
Don’t have up to date license info. But ASM-only and AWAF-only seems to have existed. Both with limitations though.
https://my.f5.com/manage/s/article/K62450265
https://my.f5.com/manage/s/article/K44569561
While never seen it in person, I do recall it from documentation.