Hi Everyone,
I have two VIPRION chassis with 3 blades per chassis, I have observed a Failover RJ-45 port on each blade. I would like to know how can i utilize these ports for fail-over configuration??
Regards,
Hi Everyone,
I have two VIPRION chassis with 3 blades per chassis, I have observed a Failover RJ-45 port on each blade. I would like to know how can i utilize these ports for fail-over configuration??
Regards,
I would like to know how can i utilize these ports for fail-over configuration??
no, i do not think so.
Hi Nitass,
Thanks for the reply but what is the propose of the Fail-over Ports than??
Hi,
see below, the port is not used on the Viprions
SOL12326: Serial failover is not supported between VIPRION chassis
SOL13915: Configuring network failover for redundant VIPRION systems (11.x)
cheers
Thanks Arpydays