displaying ARP cache for non-default routing domain

Hi,

I have multi-segment BigIP LTM deployed. Does any one have an idea how to display ARP cache for non-default routing domain ?

Both “arp -an” from bash and “show /net arp” from TMSH display only entries associated with VLANs in default routing domain.

thanks,

Marek

Hi Marek,

I’m not sure on this one. If you don’t get a reply here, you could open a case with F5 Support. If you get an answer could you reply back here for future reference?

Thanks, Aaron

Great. Thanks for the info.

Aaron

Now that bigpipe is getting old and version 11 focus on tmsh, is there a similar command that I can run in tmsh?

I tried this:

show | grep

but that shows nothing. I have to admit that I ran this on a version 10.2.2, is there a command in v11 that works?

//Ed

tmsh show net arp should get you started, don’t have a setup with multiple routing domains around to check for extra options.

e.g.

sroot@bigip1(Active)(/Common)(tmos) show net arp

--------------------------------------------------------------------------------                                                                                                 ------------
Net::Arp
Name             Address          HWaddress        Vlan              Expire-in-s                                                                                                 ec  Status
--------------------------------------------------------------------------------                                                                                                 ------------
10.10.10.101%10  10.10.10.101%10  0:50:56:b3:8:d3  /Common/internal  293                                                                                                             resolved
10.10.10.102%10  10.10.10.102%10  0:50:56:b3:8:f7  /Common/internal  296                                                                                                             resolved