about the HA feature of two F5 BIG-IP 1600 LTM load balancers

Dear all F5 experts,

I have two F5 BIG-IP 1600 LTM load balancers. One F5 BIG-IP 1600 is active status & another F5 BIG-IP 1600 is standby status.

Thus, I think all the network traffic to the virtual IP must pass through the active F5 BIG-IP 1600.

I guess the standby F5 BIG-IP 1600 just keep at standby mode and no network traffic pass through it.

However, on “Module Statistics of Network → interface statistics” of standby F5 BIG-IP 1600, there are a lot of network traffic on the data interfaces of standby F5 BIG-IP 1600.

May you please give some advice on the questions below ?

Is the standby F5 BIG-IP also work at the same time as active F5 BIG-IP is working ?

OR Is all the network traffic must pass the active F5 BIG-IP 1600 firstly unless active F5 BIG-IP 1600 is down ?

Thanks very much,

Roc

All production traffic will pass through the active unit in the HA pair. The traffic you see on your standby unit is probably communication between the two BIG-IP appliances. If you have mirroring enabled, then the active unit will constantly be sending information to the standby in the event of a failover.

You can verify this by running a tcpdump on your standby unit and seeing what source the traffic is coming from:

tcpdump -nni 0.0

Thanks Cory !

May you please give advice on another question below ?

How can I swap the active F5 role from one F5 BIG-IP 1600 to another F5 BIG-IP 1600 ?

Should I need shut down the active F5 BIG-IP 1600 so that another F5 BIG-IP 1600 can take up the active F5 role ?

Thanks very much !

Regards,

Roc

You can run this command from TMSH:

run /sys failover standby