Forum Discussion
Mario_Eury_6049
Nimbostratus
NimbostratusSwitch Command
I'm trying to use the "switch" syntac command to load balance traffic based on a client's subnet/network address. I have a list of subnets that would need to be listed to load balance to the test_pool...
Mario_Eury_6049Nimbostratus
Nimbostratusthanks for the reply. I can use the if/elseif syntac, but for what i'm trying to do, that would be a long script. We use vlans and most of our segments are 64 and 128 address segments. Campus wide we have about 800 vlans. If I was to elseif all the segments for this, it would be too long. I'm trying to figure out how to use the switch command to list all my variables to test against then send the client to the right pool. Hopefully, i explained it a little better. Thanks
